Optional configuration with different price. Ultra low THD, typically 7% under full linear load (battery low).
MPPT solar charger controller available. Battery temperature sensing for increased charging precision. Auto gen start function for off grid system with generator as backup power. HP Mini Series Pure Sine Wave Inverter &Charger Ultra Low THD, Typically 7% Under Full Linear Load MPPT Solar Charger Controller Available Remote Control Available Battery Temperature Sensing For Increased Charging Precision Auto Gen Start Function For Off Grid System With Generator As Backup Power.Feature of HP Series Inverter & MPPT & Charger. Features Smart Remote Control Support Solar Panel with MPPT Function Designed to Operate under Harsh Environment DC Start & Automatic Self- Diagnostic Function Compatible with Both Linear & Non-Linear Load Easy to Install & Easy to Operate & Easy to Solve Low DC Voltage Supports Home & Office Appliances Powerful Charge Rate Up to 120Amp, Selectable From 0%-100% High Efficiency Design & Power Saving Mode to Conserve Energy Battery Priority Mode, Designates the Inverter-Preferred UPS Configuration 13 Vdc Battery Recover Point, Dedicated for Renewable Energy Systems 8 Pre Set Battery Type Selector Plus De-sulphation for Totally Flat Batteries 4-step Intelligent Battery Charging, PFC (Power Factor Correction) for Charger 8 ms Typical Transfer Time Between Utility & Battery, Guarantees Power Continuity 15s Delay Before Transfer when AC Resumes, Protection for Load when Used with Generator. Slide to the left for full table. HP MINI Pure Sine Wave Inverter/Charger. PureSine Wave/Same as input(Bypass mode). Yes, Current Limit Function(Full after 1sec). High Voltage Alarm & Fault. Narrow:47-55±0.3Hz for 50Hz, 57-65±0.3Hz for 60Hz.
Wide:43±0.3Hz plus for 50Hz/60Hz. 20A to 25A+/-5A, depending on models.
Sine wave(Grid or Generator). 50Hz or 60Hz(Auto detect). Narrow:47±0.3Hz for 50Hz, 57±0.3Hz for 60Hz. Wide:40±0.3Hz for 50Hz/60Hz.
Narrow:48±0.3Hz for 50Hz, 58±0.3Hz for 60Hz. Wide:45±0.3Hz for 50Hz/60Hz. Narrow:55±0.3Hz for 50Hz, 65±0.3Hz for 60Hz. Wide:No up limit for 50Hz/60Hz.Narrow:54±0.3Hz for 50Hz, 64±0.3Hz for 60Hz. On the rear panel of inverter, there are 5 DIP switches which enable users to customize the performance of the device. Low Battery Trip Volt: The Low Battery Trip Volt is set at 10.0VDC by default.
It can be customized to 10.5VDC AC Input Range: There are different acceptable AC input ranges for different kinds of loads. It can be customized from 184-253VAC to 154-253VAC. Load Sensing Cycle: The inverter is factory defaulted to detect load for 250ms in every 30 seconds. This cycle can be customized to 3 seconds thru the SW3 on DIP switch. Frequency adjust: The frequency of the inverter is arranged by the Sw4.The factory default configuration for 220/230/240VAC inverter is 50Hz, and 60Hz for 100/110/120VAC inverter. While the output freq can be easily changed once a qualified freq is applied to the inverter. Solar / AC Priority Setting: Our inverter is designed AC priority by default. This means, when AC input is present, the battery wil be charged first, and the inverter will transfer the input AC to power the load.
The AC Priority and Battery Priority switch is available upon request. When you choose battery priority, the inverter will inverting from battery despite the AC input. Before you paying the order, you should see the technical parameter carefully and confirm the inverter / automatic voltage regulator / stabilizer / solar controller / transformer / uninterrupted power supplier (UPS) can meet your requirement and solve your problem. Where do you need the inverter used for?Whats the type of the load and the total load capacity? Whats the input DC voltage? Whats the output AC voltage do you need? Whats the kind of your battery? Lithium or others If you used the Lithium battery, please share the battery parameters with us to matching the inverter, such as the Rated voltage, Over voltage & Under voltage protecting parameter. Whats the type of yo. If you have the solar power, do you need the related MPPT? If yes, please share the total capacity of solar panels. If you need the related MPPT, do you need the external single MPPT or the build-in MPPT? The build-in MPPT is built into the Inverter as an integrated Inverter. The item "DC12V/24V 600W HP-MINI pure sine wave power inverter/battery charger off-grid" is in sale since Friday, March 27, 2020.
This item is in the category "Home & Garden\Home Improvement\Electrical Supplies\Alternative Energy Supplies\Alternative Energy Chargers & Inverters". The seller is "jackyzhang910" and is located in Wenzhou, Zhejiang. This item can be shipped worldwide.